Raspberry Pi Manual Setup Instructions

Raspberry Pi Installation

• Install 2015-02-16-raspbian-wheezy.img onto an SD card. (I use Win32DiskImager) Do NOT use an older version!

• Start your Raspberry Pi

• Depending on your projector hardware you may want to remove the # from the #disable_overscan=1 line located in the /boot/config.txt file

• Type the following at the command line:

sudo raspi-config

• Choose and enable the following options from the Raspberry Pi Software Configuration Tool:

• Expand Filesystem
• Enable Camera
• DO NOT choose "Enable Boot to Desktop" (CWH will not be able to detect your displays with this option enabled)

• Choose to reboot the Raspberry Pi when you are prompted by the configuration tool.
• After the Raspberry Pi has completed rebooting, execute the following commands at the command line:

  sudo wget https://github.com/area515/Creation-Workshop-Host/raw/master/host/bin/start.sh
  sudo chmod 777 start.sh
  sudo ./start.sh

• Automatically find your printer with the browseprinter client if you don't know the ip address and port of your Raspberry Pi. Or use your favorite browser and try:

http://[RaspberryPiIp]:9091

• Here is an installation video that describes the entire process from scratch https://www.youtube.com/watch?v=ng1Sj2ktWhU