Does this library support A1 Antenna antenna card reading?

[chcmq]

How should I implement this part of the logic?

[chcmq]

This is the antenna I use. I have been unable to read the card after I put the card in the sensing area of the antenna. The following is the serial port printing data：
No RX, irq1: 61 irq0: 28
Could not determine UID, perhaps some cards don't play well with the other cards? Or too many collisions?
loop..
CLRC663 fifo_length: 0
cmd_transceive rx_len: 0
Sending REQA
No RX, irq1: 61 irq0: 28
Could not determine UID, perhaps some cards don't play well with the other cards? Or too many collisions?
loop..
CLRC663 fifo_length: 0
cmd_transceive rx_len: 0
Sending REQA
No RX, irq1: 61 irq0: 28
Could not determine UID, perhaps some cards don't play well with the other cards? Or too many collisions?
loop..
CLRC663 fifo_length: 0
cmd_transceive rx_len: 0
Sending REQA
No RX, irq1: 61 irq0: 28
Could not determine UID, perhaps some cards don't play well with the other cards? Or too many collisions?

[peturdainn]

So much can go wrong...
First step: is the antenna and RF part working? If you have a scope, twist some wire around a pencil to form a coil, and attach it to the scope probe and see if the antenna is producing a field.