MAX! Window Sensor

[Tzaphkiel]

Hello,

stumbled upon your repository whilst searching how to dump and set full MAX Cube config.
This cmd line interface is SOOO much better than their interface to setup a whole installation. Much faster.
I'm using now HA to control the installation but once in a while it causes the Cube to loose or corrupt the complete config.

So to cut short, I have :

• two window sensors
• a ECO switch

as well as what you cover already:

• Thermostatic Valves
• Wall thermostat.
  The wall thermostat is in status ERROR for some reason.

Like I said, I have to window sensors and wish to help. I'm a developer but I do not know PERL per say...

How can I help integrate these window sensors and resolve the Wall thermorstat ERROR status ?

pi@raspberrypi:~$ max status
* Salon-Sam(1)
    Thermostat mur Salon(123123) manual@5.0 (current 20.4) ERROR
    Radiateur CUISINE(123123)    manual@5.0 (valve at 0%)
    Radiateur SALON(123123)      manual@5.0 (valve at 0%)
    Radiateur SAM(123123)        manual@5.0 (valve at 0%)
* SDB(2)
    Radiateur SDB(123123)        auto@15.0 (valve at 0%)
* Chambre a coucher(3)
    Radiateur CHAMBRE(123123)    auto@5.0 (valve at 0%)

Side question: do you think it would be possible to dump and restore the config ?
Looking at the status printout and the sequence of steps, appart from the 'discovery/pairing', it should be possible to send the sequence of operations to setup/restore a whole installation, no ?

[Juerd]

Thanks for your message! Unfortunately I currently don't have the spoons to work on this project.

I'm using now HA to control the installation but once in a while it causes the Cube to loose or corrupt the complete config.

The cube does that all by itself. I've had it lose its config during a month where I didn't even use any software, and one time, it's lost the config a few seconds after succesfully spewing out its normal status.

The wall thermostat is in status ERROR for some reason.

That's a thing that happens. The error flag as reported by the cube sometimes just stays there forever until the cube reboots, or if you're unlucky, until you've removed and re-added the device.

Side question: do you think it would be possible to dump and restore the config ?

At least partly (names etc), that should be possible. However, I don't know of any non-interactive way to pair a device, so you'd still have to walk around and press those buttons